Lansky Tri-Stone Bench Stone

 

The Lansky Tri-Stone Bench Stone is an economical system with coarse, medium and fine grits. Each of the three sides not only has a different grit but a different material chosen specifically for the application. The coarse is a fast sharpening diamond stone. The medium is an aluminum oxide stone. The fine is a ceramic stone which leaves a very fine surface on the edges of knives and tools. Each stone measures 6″ x 2″.

All of the stones are securely held in the Tri-Stone base. There is no need for an additional stone holder, the base holds the stones in a nice position above your work surface. Rubber feet keep the base stable and secure.

This product is made in the USA by Lansky.

Instructions:

Step 1– Select the proper stone for your edge.

Coarse Diamond Stone – For re-profiling a completely dull or damaged edge
Medium Alumina Oxide Stone – To maintain an undamaged, slightly dull edge
Fine Ceramic Stone – To hone/polish a finished edge

Step 2 – Set the Tri-Stone Benchstone base on a stable, flat surface with the stone you have selected facing up.

Note – Lubrication of any kind is not recommended while sharpening on any of the three stones. DO NOT USE HONING OIL ON THE DIAMOND STONE.

Step 3 – Observe the bevel angle on the blade you intend to sharpen. Then, bring the edge to the stone matching your sharpening angle to the bevel angle.

Step 4 – Using light pressure, push the edge of the blade across the stone in one motion, much like trying to slice a thin layer off the top of the stone. Maintaining a consistent angle is essential for the best results.

Step 5 – Repeat process 3-4 times on one side of the blade then switch to the other side and repeat.

Step 6 – Repeat this process until edge is sharp then progress to finer stones and repeat.